Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
Using intelligent control pressure relief system, Measurement range 10~ 1600kPa, Indication Error ≤ +/- 0.5%, all-steel chain drive to improve Stability, real-time observation of test sample blasting process.
High borosilicate Glass material, corrosion resistance and can withstand large thermal Impact, vacuum negative pressure of 0.095MPa, Speed range 50~ 500rpm, suitable for material synthesis and distillation recovery.
The pressure column and ball joint structure are used to ensure that the test surface is close, the pressure column mass is 250g, the bottom surface diaMeter is Φ 50 +/- 1mm, and it is equipped with 100g to 500g weight, which can simulate the contact performance of coatings under different pressure conditions.
Constant pressure ensures uniform sampling, suitable for a variety of powder material testing, implementation of GB9087-88 and other standards, improve sampling accuracy and conformity.
Using 500g Cedar load and 30mm Cedar knife, the length of Cedar is accurately read by 20 times Microscope. The length of Cedar is inversely proportional to Hardness, and the test results can be obtained in 30 seconds with easy operation.
High borosilicate Glass material, corrosion resistance and high and low temperature resistance, strong ability to withstand thermal Impact; vacuum negative pressure can reach 0.095MPa, support material reaction under negative pressure; Overhead Stirrer Rotation speed 50-500rpm, torque 70N.cm, suitable for a variety of viscosity materials.
Manual pressure control pressure holding operation is simple, electronic pressure holding device reduces mechanical abrasion, pressure range 0~ -90kPa, accuracy +/- 0.1kPa, Organic Glass sealing barrel wall thickness 15mm to enhance compressive strength.
Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Using high elasticity standard rubber and denim for extrusion test, extrusion pressure 10-120kgf adjustable, Test speed 5-30 times/minute, to meet the requirements of YD/1539-2006 standard.
The nib is 1mm in diaMeter, equipped with three springs covering the 0-30N pressure range, and the tungsten carbide tip can leave visual marks to evaluate surface Hardness, ergonomically designed non-slip grip.
The equipment is designed according to the international coating stain resistance experimental method, the water Tank volume is 5L, the inner diaMeter of the flow pipe is 8mm, and the time control range is 0~ 99h99s. It is suitable for the stain resistance test of building exterior coatings.
4-Terminal Resistance Measuring method is used to eliminate the influence of wire resistance. Test speed is up to 6 times/sec. Measurement current is less than 100mA to prevent temperature drift and ensure Precision and Stability.
Using high borosilicate Glass material, corrosion resistance and can withstand -80~ 200 ℃ Operating temperature, vacuum negative pressure of 0.095MPa, equipped with PTFE four-leaf stirringRod and RWD50 top Stirrer, Speed range 50~ 500rpm, support precise control and uniform material reaction.
Using 2-wire method and 3-wire method measurement, Ground Voltage Measurement range 0~ 200V, Ground Resistance Measurement range 0~ 1999 Ω, Response Time about 5 seconds, with continuous measurement and overload protection function.
