Brushless DC motor, Rotation speed 100rpm, support positive and negative rolling mode, compatible with different size testtube, low noise and maintenance-free operation, suitable for long-term continuous operation.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Brushless DC motor, Rotation speed 100rpm, low noise maintenance-free, support normal and negative two rolling modes, compatible with different size testtube, gentle rolling to ensure sample safety.
Rotation speed 100rpm, low noise and maintenance-free; support positive and negative rolling swing mode, compatible with different size testtubes, gentle rolling to ensure sample safety, continuous operation and reliability.
DC brushless motor, Rotation speed 100rpm, support positive and negative rolling mode, gentle mixing and compatible with a variety of testtube sizes, suitable for long-term continuous operation, low noise and maintenance-free.
Equipped with three sets of independent rollers, load accuracy of +/- 5g, rolling speed of 300mm/min, can accurately simulate the bonding effect of materials under different pressure conditions, rubber wheel Hardness Hs80 +/- 5 to ensure test conformity.
Adjustable tilt angle 0~ 40 °, the steel ball meets the standard of GB/T308 grade 40 or above, which is convenient for angle and position adjustment.
Brushless motor to avoid Toner contamination of samples and reduce noise. The processing capacity covers 150 ml to 6 liters, supports a variety of head Modular replacements, and the intelligent Touchscreen can set the program, timing, line speed and torque.
32 5ml centrifuge tubes can be installed vertically on both sides, using a vertical installation design, suitable for HT-X100 swirl/spin Mixer, improving Sample Handling efficiency.
The homogenizing time is up to 3000 seconds, the speed range is 100-10000rpm, and the acceleration is 100-10000rpm/s. It supports multi-stage program control. Vacuum chuck ensures the stability of the substrate and is suitable for assembly line processes.
Adopt oblique block to adjust the gap, good self-cumbersome and high adjustment accuracy; Roller cylindricity ≤ +/- 2um, Hardness up to HRC62 and hard chrome plating to prevent rust; Electric rolling can be reversed, and the film thickness and speed can be adjusted.
Double-sided horizontal mounting design can accommodate 40 centrifuge tubes simultaneously, compatible with 1.5ml and 2.0ml specifications, suitable for swirl/spin Mixer for efficient Sample Handling.
Adopting rotary oscillation design, Frequency 3000rpm, pendulum amplitude 5mm, suitable for small containers such as testtube and Colorimetric tube, it can efficiently handle the experimental requirements of large chemical reactions and few solutions.
Using the rotary oscillation mode, Oscillation Frequency up to 3000 rpm, swing amplitude of 5mm, through smooth contact to achieve rapid mixing, speed can be adjusted with pressure, suitable for a variety of laboratory applications.
