11/16 inch standard width paper tape, capable of completing approximately 1800 cycles of testing per roll, must be stored at 23 +/- 2 ° C and 50 +/- 10% Humidity to ensure Stability.
Equipped with 10-station synchronous test capability, 1000g weight and 1-999999 minute Timer, using SUS #304 steel plate to ensure test accuracy, and automatically recording tape peeling time.
The adhesive force of the tape is 4.3N/cm, and the principle of cross-cut method is adopted, which is suitable for adhesion testing. The performance is stable and non-degumming, and the test results are accurate and reliable.
Adopt replica tape method to measure surface roughness, Peak Measurement range 20~ 115μm, accuracy +/- 5μm, with automatic subtracting substrate function, High Protection Rating, anti-solvent and water dust.
With two test stations, the load range is 50~ 1000g, and three typical wear resistance tests of alcohol, eraser and pencil can be carried out, which is suitable for wear resistance evaluation of various coatings and materials.
Measured value 500N, suitable for tape, leather, clothing, rubber, electrical components, paper and other materials, assist Force Gauge in tensile testing to ensure test Stability and accuracy.
The width is 11/16inch, and each roll can be tested for about 1800 turns. It needs to be stored at a temperature of 23 +/- 2 ° C and a Humidity of 50 +/- 10% environment to ensure test Stability and Repeatability.
Measured value 500N, suitable for tape, PCB, adhesive tape and other materials disbonding force test, supporting the Force Gauge test bench.
Measured value 50000N, suitable for tape, leather, paper and other sheet or block material push-pull force and destructive force test, supporting the Force Gauge test bench.
Using 2000g +/- 5g roller load and 300mm/min rolling speed to ensure that the adhesive tape sample is flat and evenly adhered to the standard substrate, in line with CNS-11888 and PSTC-8 design standards.
Vacuum principle measurement paper breathability performance, Measurement range 0-1000ml/min, test area of 10cm ², suitable for a variety of industrial paper mass detection.
Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
It adopts wear-resistant inks and thickened steel knife design, is equipped with paper cutting guide ruler and paper pressing anti-skid function, and the sampling size is 380 * 300mm to ensure accurate sampling and stable operation.
Rotation speed 40rpm and roller diaMeter 150mm design, suitable for a variety of resilience material testing, abrasion Travel 40mm, test load optional 5N or 1N, to ensure efficient and accurate wear performance evaluation.
Double station design can simultaneously carry out two sets of tests, round trip 0-50mm adjustable, test load 80-990g adjustable range, equipped with a variety of weight to meet the wear resistance performance evaluation requirements under different load conditions.
