Using roll-to-roll continuous solution pool mode, the width of the substrate is 200mm, and it is dried by 130 ° C hot air Oven; the solution pool can be lifted and heated, and PLC control ensures stable operation, which is suitable for a variety of substrate processing.
Using a roll-to-roll continuous solution cell process, the substrate is crystallized or attached under specific conditions. Equipped with a 130 ° C hot air Oven drying system, the effective application width is 180mm, and the mechanical speed range is 0.1-300 mm/min. The solution cell has a lifting function and a separate heating design to ensure process Stability and operation safety.
Adopting double roll extrusion method, Spreader Film thickness range 0.3-10 mm adjustable, accuracy up to +/- 0.05mm, equipped with handwheel adjustment and dial indicator display, dip plate is 304 stainless steel material.
Adopting dip coating with double roll extrusion structure, Spreader thickness 0.3-10 mm adjustable, mechanical speed 1.2m/min can be slowly adjusted, built-in glue circulation system to ensure Spreader uniformity.
Using D type High Accuracy Impact device, Measurement range 30~ 110HS, can detect cast steel roll, forged steel roll and cast iron roll three kinds of hardness of materials, with anti-Impact and anti-electromagnetic interference ability, support 7 kinds of Hardness standard automatic conversion.
Using dip coating process with double roll extrusion residual material, Spreader thickness adjustable, mechanical speed 0.1-1 m/min, Oven temperature 50-150 ℃ +/- 3 ℃, suitable for a variety of Coating Spreader.
Using the immersion coating method, Spreader thickness 0.3-10 mm adjustable, mechanical speed 1.2m/min, built-in glue circulation system to ensure uniform and stable Spreader.
Adopt Cr12 steel roll, Hardness reaches HRC52 °~ 58 °, surface roughness 0.2~ 0.1, speed ratio 1:3:9, easy to operate and low noise, suitable for efficient grinding of various materials.
Laminating speed 1~ 10m/min, laminating accuracy 0.5mm, roll to roll Laminating design, equipped with automatic deviation correction device and split drying, suitable for a variety of non-elastic material Spreader.
Adopt double roll extrusion method to achieve 0.3-10 mm Spreader Film thickness, accuracy of +/- 0.05mm; Equipped with hot air circulation Oven, Temperature range room temperature to 200 ℃ +/- 3 ℃; Tension controller automatically controls the unwinding process to ensure the uniformity of Spreader.
Using nitrile rubber material, length 100mm diaMeter 20mm, with excellent oil resistance and aging performance, suitable for inks proofing operation.
Maximum load 0.5KN, specially designed for rubber materials to ensure stable and reliable tensile testing, suitable for a variety of Rubber mechanical properties testing.
The Spin Coater is controlled by touch screen, the acceleration range is 100~ 4000rpm/s, and the speed can be automatically corrected by A/K selection. The motor torque is large and the operation is smooth, which is suitable for the assembly line process.
Adopt Cr12 steel roll, Hardness reaches HRC52 °~ 58 °, Surface Hardness 0.2~ 0.1, easy to operate and easy to change color, suitable for fine grinding of material viscosity 30~ 8000cps range.
The three-roll extrusion grinding principle is adopted, the diaMeter of the roller is 65mm, the processing viscosity is 3 million cps, and the temperature can be controlled by chilling down water. The material of the roller can be selected from cemented carbide or zirconia ceramics.
