Equipped with three sets of independent rollers, load accuracy of +/- 5g, rolling speed of 300mm/min, can accurately simulate the bonding effect of materials under different pressure conditions, rubber wheel Hardness Hs80 +/- 5 to ensure test conformity.
Adopt oblique block to adjust the gap, good self-cumbersome and high adjustment accuracy; Roller cylindricity ≤ +/- 2um, Hardness up to HRC62 and hard chrome plating to prevent rust; Electric rolling can be reversed, and the film thickness and speed can be adjusted.
Brushless DC motor, Rotation speed 100rpm, support positive and negative rolling mode, compatible with different size testtube, low noise and maintenance-free operation, suitable for long-term continuous operation.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Brushless DC motor, Rotation speed 100rpm, low noise maintenance-free, support normal and negative two rolling modes, compatible with different size testtube, gentle rolling to ensure sample safety.
Rotation speed 100rpm, low noise and maintenance-free; support positive and negative rolling swing mode, compatible with different size testtubes, gentle rolling to ensure sample safety, continuous operation and reliability.
Using stainless steel material, range 0~ 300μm, Graduation 15μm, wheel structure with dial, by comparing Coating adsorption quickly read Film thickness, to ensure the construction mass.
Using stainless steel material, range 0~ 50μm, Graduation 2μm, wheel structure with dial, by comparing the scale and Coating adsorption quickly evaluate the wet film thickness to ensure the construction mass.
Made of stainless steel, range 0~ 100μm, Graduation 5μm, wheel structure with dial, can quickly and accurately read the wet film thickness, to ensure the construction mass of Coating.
Using stainless steel material, range 0~ 2000μm, Graduation 100μm, wheel structure with dial, by comparing the scale and Coating adsorption quickly evaluate the wet film thickness to ensure the construction mass.
Made of stainless steel, range 0-1000 μm, Graduation 50 μm, wheel structure with dial, can quickly and accurately read the wet film thickness, suitable for a variety of Coating application scenarios.
Made of stainless steel, range 0~ 200μm, Graduation 10μm, wheel structure with dial, rapid and accurate evaluation of wet film thickness by comparing Coating adsorption, easy to operate.
Made of stainless steel, range 0~ 500μm, Graduation 20μm, wheel-shaped structure with dial, can quickly and accurately read the wet film thickness, to ensure Coating construction mass.
Using stainless steel, range 0~ 25μm, Graduation 1μm, wheel structure with dial, through the inner and outer rim clearance contrast quickly read the wet film thickness, in line with a number of international standards.
