The 4-sided paint design can be prepared with four different thickness wet-film, application width 75mm, accuracy +/- 3μm, corrosion-resistant stainless steel material, easy to clean and durable.
Made of stainless steel, with 6 precision teeth, the spacing is accurate to 1mm, and the cutting edge is kept sharp to ensure the accuracy and Repeatability of the paint film test.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Made of stainless steel, with 6 cutter tooth designs, with a cutter tooth spacing of 3mm, strong durability and stable cutting effect, suitable for accurate paint film testing requirements.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Hand type easy to operate, load 1000g, standard 6B-6H pencil, suitable for film hardness testing, test temperature 23 +/- 2 ℃ and Humidity 50 +/- 5% environment.
The number of teeth 6, spacing 3mm, using circumferential multi-faceted cutter surface design, long service life, suitable for film thickness greater than 120 μ m hard substrate test cross-cut.
Manual design, equipped with a 6-tooth cutting knife, with a 1mm and 2mm tooth spacing, in line with ISO2409 standards, suitable for adhesion testing in laboratories and construction sites.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0-10.5 mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
The device can be prepared with 12 wet film thicknesses, ranging from 30-600μm, accuracy up to +/- 002-0.012 mm, 4-sided design to ensure that the coating does not spill, suitable for a variety of substrate surface Spreaders.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
Using 180 * 480mm size, with wire Rod or Film Applicator scraping ink, is conducive to the film flat and effective, improve film mass.
Adopting 500 * 700mm Dimensions, used with bar or Film Applicator, is conducive to the smooth and effective film, and improves the convenience of film operation.
Effective Spreader width 300mm, suitable for all kinds of scraper type Film Applicators, to ensure the uniformity of Spreader, improve the film accuracy and conformity in the experiment or pRoduction.
The pressure range of the probe is 50~ 250N, the diaMeter of the rubber probe is 40mm, and the degree of paint film chalking is evaluated by comparing the imprint of the photo paper with the standard sample, which is suitable for the detection of various environmental factors.
