Double pointer design for easy reading, Pin Travel 0~ 2.5mm, Measurement range 0~ 100HD, error +/- 1HD, lightweight and portable only 0.16kg, suitable for on-site Hardness detection.
Can be used with A type or C type Shore DuroMeter, fixed load weight mass 0.75 +/- 0.05kg, hardness Gauge clamping Rod connection size M7x0.5mm, improve hardness testing accuracy and Stability.
With tracking pointer and peak pointer double pointer design, pressing needle Travel 0-2.5 mm, Measurement range 10-90Hc, suitable for material testing with pressure above 0.049MPa when the compression rate is 50%, and can be matched with test bracket to improve Stability.
Supporting D-type Shore DuroMeter, applying 5kg test force by weight, equipped with Glass bench and adjusting nut to ensure full contact with the sample and improve measurement Stability.
Pin Travel 0~ 2.5mm, Measurement range 0~ 100HA, Error +/- 1HA, Dual pointer design can display real-time and peak Hardness value at the same time, easy to use handheld or rack.
Suitable for low and medium Hardness material measurement, pressure needle end pressure 0.55N-8.06N, pressure needle stroke 0-2.5 mm, can be matched with test rack to reduce manual operation error, improve test accuracy and Repeatability.
Adopt double-pointer design, pressure needle Travel 0~ 2.5mm, measurement error +/- 1HAO, can be handheld or used with the bench, suitable for stable and fast detection of low Hardness rubber materials.
Dial design can maintain the maximum Measured value display, Measurement range 0-100 Shore, accuracy up to 1shore, made of wear and corrosion resistant stainless steel aluminum oxide material.
Suitable for materials such as high Hardness rubber and engineering plastics, pressing needle Travel 0~ 2.5mm, Measurement range 0~ 100HD, error +/- 1HD, in line with ASTM D 2240-05 and GB/T2411-2008 standards.
Double pointer design can be used with rack or hand, pressing needle Travel 0-2.5 mm, measurement error +/- 1HA, suitable for rubber and plastic hardness testing.
Dual pointer design can display the current value and peak value at the same time, the pressure at the end of the crimp is 445mN, and the measurement error is +/- 1HD, which is suitable for plastic sample condition adjustment testing.
Suitable for thin samples with a thickness of less than 6mm, featuring multiple testing modes such as real-time, peak, automatic timing, and average value. It can be connected to a computer for data management and curve analysis.
Digital display design, compact and easy to operate, Measuring accuracy, low power consumption, easy to carry, suitable for field and laboratory rapid Hardness detection.
Using D type High Accuracy Impact device, Measurement range 30~ 110HS, can detect cast steel roll, forged steel roll and cast iron roll three kinds of hardness of materials, with anti-Impact and anti-electromagnetic interference ability, support 7 kinds of Hardness standard automatic conversion.
Tempered Glass platform, long-term use is not easy to abrasion and rust; the level of the working platform is adjustable, and the hardness Gauge is adjusted to the same level; the weight is accurate, the column lifting space is ≤ 140mm, Dimension 165 * 145 * 380mm.
