The circular track is used to automatically record the film drying process continuously, equipped with 4 kinds of specifications to choose from, the track diaMeter is 100mm, and the measurement error is +/- 0.5%, which can intuitively analyze the stages in drying state.
Coating speed 1~ 10m/min adjustable, Spreader thickness range of 0.005-3mm, drying temperature up to 200 ℃, equipped with infrared drying and air cooling system to achieve efficient Spreader and drying.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
It can measure drying time from 1 minute to 48 hours, with accuracy up to 10 seconds, and has intelligent recording function to improve the resolution of long drying process, which is suitable for various coating types.
Equipped with 6 strokes and 305mm Travel, it can automatically record four stages of the drying process continuously, and intuitively display the curing state of the paint film through the straight track, and the measurement error is controlled within +/- 4%.
Using stainless steel material, bottom area 1cm ², weight 200g, in line with GB/T 1728 standard, can accurately determine the film and putty film surface drying time.
Using 200 +/- 0.2 g weight and 1 square centiMeter bottom area design, the drying process of the paint film was accurately determined by the cotton ball method to distinguish between surface drying and actual stages in drying.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Using nylon mesh and weight combination test, equipped with 200g to 1000g multi-specification weight, can accurately detect the surface imprint condition after coating drying, in line with international standards.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
The equipment uses 200 +/- 0.2g weight, sample size 50 * 120 * (0.2~ 0.3) mm, can accurately determine the surface and actual drying time, in line with national standards.
Adjustable Blade Coating device to achieve 0.005-3mm thickness control, equipped with 200 ℃ heating roller and 1 Meter drying tunnel, support 1-10m/min continuous coating speed, with automatic correction function to ensure material alignment.
Coating speed 1~ 10m/min adjustable, wet film thickness range of 0.005-3mm, drying temperature up to 200 ℃, using continuous experimental film design, equipped with adjustable Blade Coating device and automatic deviation correction function.
Using the formed pRoduction process, Coating Weight is about twice that of the wire-wound coating Rod, wet film thickness is 13μm, film accuracy reaches 0.5 μm, and the material is 304 stainless steel.
The instrument adopts a six-pin design, forms plow marks on the paint film through uniform linear motion, and automatically displays the drying process according to the change of traces. The measurement error is controlled within +/- 4%, and supports three time settings of 6h, 12h and 24h.
