The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
Using stainless steel material, bottom area 1cm ², weight 200g, in line with GB/T 1728 standard, can accurately determine the film and putty film surface drying time.
Equipped with 6 strokes and 305mm Travel, it can automatically record four stages of the drying process continuously, and intuitively display the curing state of the paint film through the straight track, and the measurement error is controlled within +/- 4%.
The equipment uses 200 +/- 0.2g weight, sample size 50 * 120 * (0.2~ 0.3) mm, can accurately determine the surface and actual drying time, in line with national standards.
Using 200 +/- 0.2 g weight and 1 square centiMeter bottom area design, the drying process of the paint film was accurately determined by the cotton ball method to distinguish between surface drying and actual stages in drying.
The circular track is used to automatically record the film drying process continuously, equipped with 4 kinds of specifications to choose from, the track diaMeter is 100mm, and the measurement error is +/- 0.5%, which can intuitively analyze the stages in drying state.
Nominal Mass 200 +/- 0.2g, bottom area 1cm ², using computer information acquisition processor to complete the experimental process to ensure accurate and reliable data.
The instrument adopts a six-pin design, forms plow marks on the paint film through uniform linear motion, and automatically displays the drying process according to the change of traces. The measurement error is controlled within +/- 4%, and supports three time settings of 6h, 12h and 24h.
It can measure drying time from 1 minute to 48 hours, with accuracy up to 10 seconds, and has intelligent recording function to improve the resolution of long drying process, which is suitable for various coating types.
The equipment can detect the crazing or peeling of the putty film after bending, equipped with R25 and R50 support film specifications, shaft Rod size is 50mm and 100mm in diaMeter, suitable for 0.2-0. 3mm thick tinplate plate.
The device provides 3 +/- 0.3m/s wind speed through axial flow fan in wind tunnel, Timer delay range of 0.01 seconds to 99 hours 99 minutes, can automatically control drying time and eye test plate surface crazing, support parallel test.
The device places the test plate in parallel in the wind tunnel, the wind speed control accuracy is 3 +/- 0.3m/s, the drying time is automatically controlled, and the surface crazing can be visually inspected, which is suitable for the evaluation of coating anti-crack performance.
The instrument uses 241 +/- 6mm tire uniform rolling detection, wet film thickness 200um +/- 20um, every 30 seconds, repeability test, accurate determination of non-stick tire drying time, suitable for marking Coating quality control.
