Measurement range 0-99.9%, resolution 0.1%, Response Time 1 second, portable design supports rapid on-site detection, probe Sensor can penetrate deep into the material internal measurement.
Adopt all directions swing vibration mode to ensure that the paint is fully mixed, Vibration Frequency 550 times/min, equipped with 0-15 minute timing function, suitable for 80-240mm barrel height range.
Using high frequency principle, Measurement range 0-60%, accuracy +/- 0.5%, Response Time 1 second, probe Sensor can penetrate deep into the material, support 20 kinds of material code selection.
Using high frequency principle to achieve 0~ 99.9% moisture measurement, probe Sensor can penetrate deep into the material, Response Time is less than 1 second, support on-site rapid detection and 9 sets of measurement codes.
Using high frequency principle, Measurement range 0-99.9%, resolution 0.1/0, Response Time 1 second, portable design can be deeply measured inside the material, backlit LCD display is clear and low power consumption.
Using high frequency principle, measurement range 0-90%, resolution 0.1/0, Response Time 1 second, Sensor and host split design, Portable structure is suitable for on-site rapid detection.
Adopting the principle of high-frequency electromagnetic wave induction, scanning depth 50mm, Response Time 1 second, support multi-gear measurement and plug-in rapid detection, small size for on-site use.
The equipment supports 0.5-20 liters of barrel paint mixing, revolution speed 100-200rpm, rotation speed 200-400rpm, using multi-stage intelligent frequency conversion speed regulation and door opening and shutdown protection to achieve smooth operation and safe operation.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Using a 29.7 × 29mm pump and a 2 kg load weight, the material consistency was accurately determined by the spread diffusion diaMeter of the Basis Weight specimen on the Glass platen, meeting the standard test requirements.
Stainless steel material to ensure durability, 50ml standard volume design, cover with overflow holes for accurate measurement of liquid density, in line with international testing standards.
304 stainless steel material corrosion resistance, Operating Pressure up to 8kg/cm2, temperature measurement accuracy +/- 0.1 ℃, pot body rotation design makes the raw materials mix evenly, electronic control system brushless conductive to avoid common failures.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
