Overview
The LANYU 30G Homogenizer is an optional dispersion head device. The Stir volume is 10-8000ml, the Stir viscosity is 6000mPa.s, and it is made of 316L stainless steel. Specifications include 100-8000ml processing capacity, maximum processing viscosity 6000CP, maximum operating temperature 120 ° C, stirringrod length 235mm, stator diameter 30mm, working head material SS316, shaft sleeve material PTHE, maximum rotor linear speed 22m/s, minimum immersion liquid height 60mm, maximum immersion liquid height 170mm.
Features
1. Optional dispersion head, Stir amount range 10-8000ml;
2. Stir viscosity up to 6000mPa.s;
3. Using 316L stainless steel material, strong corrosion resistance;
4. The maximum linear speed of the rotor reaches 22m/s, with high homogenization efficiency.
5. The working head material is SS316, and the bushing material is PTHE to ensure durability;
6. Adapt to a wide temperature range, the maximum operating temperature is 120 ° C;
7. The height of the immersion liquid is adjustable, with a minimum of 60mm and a maximum of 170mm.
Principle
The LANYU 30G Homogenizer generates shear force through a high-speed swirl/spin rotor, combined with the stator structure, to achieve uniform mixing and dispersion of materials, suitable for the treatment of high viscosity liquids.
Applications
Chemical, pharmaceutical, food, cosmetics, laboratory research
Steps
1. Check the integrity of the equipment to ensure that the working head is firmly installed.
2. Set the Stir parameter according to the processing capacity, and adjust the immersion liquid height between 60-170mm;
3. Start the equipment, monitor the operating status, and ensure that the viscosity does not exceed 6000CP;
4. After the operation is completed, clean the working head in time to avoid material residue.
Notice
Make sure the liquid temperature does not exceed 120 ° C before use.
• The height of the immersion liquid shall not be less than 60mm or more than 170mm.
• Avoid operating under conditions exceeding the maximum viscosity of 6000CP;
• Regularly check the abrasion of the working head and bushing;
• Pay attention to safety during operation to prevent liquid splashing.
