Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Using reciprocating motion to simulate transportation abrasion, Friction Frequency 0~ 2.5Hz adjustable, Test Travel 12.7~ 50.8mm, support continuous test 0~ 24 hours, suitable for a variety of can sizes and pressure conditions.
Can test inks multi-directional adhesion at the same time, Friction Frequency 43cpm, Friction Load 2lb/4lb, Abrasion Resistance evaluation by measurement density or Coating thickness reduction, support 0-99999 automatic shutdown.
Scruf Travel 20-300mm adjustable, speed range 1-60cpm, equipped with TFT full color display and intelligent Operating interface, supports manual testing and is compatible with a variety of standard accessories, suitable for coating Abrasion Resistance evaluation.
Adopt reciprocating friction method, Friction Frequency 0~ 2.5Hz, Test Travel 12.7~ 50.8mm, can simulate coating abrasion during transportation, support continuous test 0~ 24 hours.
Measurement range 0~ 1250μm, suitable for LEEB220 and LEEB222 Coating thickness Gauge, Abrasion Resistance is good, suitable for a variety of nonmagnetic Coating thickness detection.
With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
Using standard sand free fall brushing layer, straight grinding to expose 4mm substrate; can quantify the abrasion per unit thickness of the paint layer of sand volume, the inner diaMeter of the catheter 19mm, sample holder 45 degrees angle fixed.
Can set the moving distance 0.5-4 inches, Rotation speed 2-60 times/min and other paraMeters, support wet and dry abrasion test, can test any size or shape sample, ensure test Stability and accuracy.
The grinding head reciprocates within 110mm Travel, and the Friction Frequency is adjustable from 20 to 60cpm. It cooperates with 1000g weight to test Abrasion Resistance under different pressures, and the digital display counter directly displays the number of frictions.
The width is 11/16inch, and each roll can be tested for about 1800 turns. It needs to be stored at a temperature of 23 +/- 2 ° C and a Humidity of 50 +/- 10% environment to ensure test Stability and Repeatability.
Three sets of samples can be tested simultaneously, supporting two standard methods of no presser foot and presser foot, adjustable fixture movement amplitude, frequency conversion speed regulation, and automatic counting and shutdown functions after reaching the set number of times.
Equipped with three sets of independent rollers, load accuracy of +/- 5g, rolling speed of 300mm/min, can accurately simulate the bonding effect of materials under different pressure conditions, rubber wheel Hardness Hs80 +/- 5 to ensure test conformity.
Adjustable tilt angle 0~ 40 °, the steel ball meets the standard of GB/T308 grade 40 or above, which is convenient for angle and position adjustment.
