Compression stroke 2.50mm, load 237g, suitable for wet mold sand/core surface Hardness measurement, support USB and Bluetooth data output, with average calculation and undervoltage alarm function.
Suitable for manual or mechanical low and medium pressure molding of fine sand core testing, compression stroke 2.50mm, load 980g, with average calculation and MAX Maximum latch function, support data output communication.
Suitable for high voltage molding sand test, compression stroke 2.50mm, load 1500g, with average calculation and MAX Maximum latch function, support USB and Bluetooth data communication.
Using 1400rpm speed regulation and 1.5 liters effective volume sand grinding basket, rapid dispersion and grinding are achieved through tensile shear and Impact between sand and material, and the operation is simple.
The variable frequency motor is used to achieve stepless speed regulation from 0 to 7500 rpm, equipped with dispersed impeller and sand grinding blades, and the dual-axis constant force lifting system has a stroke of 200mm, which can adapt to different experimental requirements and calculate the material reaction relationship.
Set dispersion and sand grinding functions in one, complete two processes in a single container, speed range 130~ 3000rpm, grinding basket size Φ 80x60mm, high efficiency and easy to clean.
Using dual-axis constant force lifting system and variable frequency motor, 0-3000rpm stepless speed regulation, equipped with dispersed impeller and sand grinding blades, can directly calculate the relationship between material viscosity and reaction rate.
1400 rpm high-speed stirring is used to achieve strong tensile shear and Impact between the material and the sand, and the fineness of grinding can reach 25 microns or less, suitable for sample testing, with a capacity of 1.5 liters.
1400 rpm high-speed stirring is used to achieve strong tensile shear and Impact between the material and the sand, the fineness of grinding can reach 25 microns or less, and the capacity is 1.5 liters, which is suitable for laboratory sample dispersion grinding.
Imported special steel pressure needle, Hardness and long life, range 0-20HW, can directly read the Hardness value, suitable for on-site rapid testing, Stability and portability.
Impact energy 11mJ, Impact device mass 50g, ball head diaMeter 3mm, Hardness measurement hole or cylinder, suitable for a variety of metal hardness of materials testing.
Suitable for medium and high viscosity materials, using bottom open turbine structure with strong suction pump effect, grinding medium diameter 0.8-2 mm, variable frequency speed range 0-1440rpm, equipped with chill down heating jacket to control material temperature.
It adopts 45 ° fixed angle design, loads 1000g +/- 10g, and evaluates Hardness by scratching coatings with different Hardness pencils, which is easy to operate and accurate.
Compact and lightweight can be operated with one hand, without support and testing experience, the test range is equivalent to brinell hardness 25~ 150HB, can measure a variety of Hardness scales and has MAX Maximum hold and average calculation functions.
Adopt four-link mechanism to ensure a constant 45 ° test angle, equipped with 500/750/1000g adjustable load, accurately determine film Hardness through different Hardness pencil scratches, meeting standard test Environmental requirements.
