White part reflectance 80 +/- 2, non-Laminating design to enhance paint wettability, test area of 0.1 square Meters, Curl and checking resistance, suitable for brushing applications.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Adopt 4mm small diaMeter design, suitable for surface or small area measurement; Repeatability Delta E * ab < 0.05 to ensure Measurement accuracy; Horizontal structure is small in size, comfortable and stable to hold.
The equipment adopts electric lifting and frequency conversion speed regulation, Rotation speed 0-3000 rpm, equipped with double-decked chilled down jacket and zirconia bead grinding medium to achieve efficient wet dispersion grinding, small temperature rise and easy operation.
Rotation speed up to 3000rpm, fineness of grinding up to 10 microns or less, double-decked chilled down jacket design makes the conventional temperature rise less than 10 ℃, zirconia dial drive grinding medium to achieve efficient dispersion grinding.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
Rotation speed up to 3000rpm, fineness of ground up to 10 microns, equipped with double-decked chill down jacket to make the temperature rise less than 10 degrees, electric lifting design easy to operate and easy to clean.
Adopt all directions swing vibration mode to ensure that the paint is fully mixed, Vibration Frequency 550 times/min, equipped with 0-15 minute timing function, suitable for 80-240mm barrel height range.
Three rollers are used to crush each other to destroy the molecular binding force, and the material is crushed and mixed. The size of the roller is 65x135mm, the rotation speed of the middle roller is 88rpm, and the particle size of the starting material is 50~ 100μm.
The tapered shaft size range is 3.2~ 38mm, and the shaft length is 203mm, which can test the cracking and disbonding performance of the paint film under bending conditions, in line with international standards.
The equipment can complete two processes of dispersion and grinding at the same time, Rotation speed 0-1500rpm, grinding capacity 30-100L, using zirconia grinding medium and chill down jacket design, temperature rise is small, easy to operate.
The adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel ≥ 80mm. The integrity of the paint film was evaluated by seven grades, and the operation was simple and conformed to the GB/T1720 standard.
Rotation speed 0-3000rpm, fineness of grinding can reach 10um or less, double-decked chill down jacket is used to control temperature rise less than 10 ℃, electric lifting operation is convenient, zirconia bead grinding medium to achieve efficient dispersion and ground synchronization.
