With 10L Processing capacity and 0.1μm discharge accuracy, four-station design and 580rpm Rotation speed, support wet and dry grinding and vacuum grinding, configuration 600CFM cooling system and a variety of materials ball mill Tank optional, good grinding conformity.
Maximum feed size 2mm, minimum discharge particle size 0.1um, support dry grinding wet grinding vacuum grinding and other methods, equipped with a variety of materials ball mill Tank, can control Rotation speed and time to ensure grinding Repeatability.
360 degree tumbling structure combined with planetary disk swirl/spin, maximum Processing capacity 80L, minimum discharge particle size 0.1μm, support dry grinding, wet grinding, vacuum and other grinding methods, equipped with a variety of materials ball mill Tank to adapt to different samples.
Adopting the principle of planetary motion, the grinding time only takes 15-20 minutes, the discharge particle size reaches 0.1 micron, supports dry grinding, wet grinding, vacuum grinding and other methods, and is equipped with a 200CFM heat dissipation system and a low center of gravity design to ensure stable operation.
With 8L Processing capacity and 0.1μm discharge particle size, four-station design and 580rpm Rotation speed, support dry grinding, wet grinding and vacuum grinding, equipped with 600CFM cooling system and a variety of ball milling Tank material selection.
Rotation speed of the ball mill can reach 1100rpm, the minimum discharge particle size is 0.1μm. It supports dry and wet milling and various material Tanks, and the grinding is uniform and efficient.
The use of diamond sanding needles can flatten the surface of the grinding wheel, improve the utilization rate of abrasive wheels, and is equipped with a water supply system to support wet grinding and dry grinding. The size of abrasive wheels is about 250 × 30 × 32mm, and the Rotation speed is 1400rpm.
With 12L maximum Processing capacity and four station design, support dry grinding, wet grinding and vacuum grinding in various ways, the minimum discharge particle size is 0.1 μm, using frequency converter and motor drive to ensure grinding conformity and efficient heat dissipation.
Processing capacity up to 80L, the minimum particle size of 0.1μm, support dry grinding, wet grinding, vacuum and other grinding methods, combined structure is easy to disassemble and maintain, configuration cooling system to ensure stable operation.
Equipped with wet grinding water supply system, stable transmission and low noise, throwing disc diaMeter 230mm, Rotation speed 900rpm, easy operation and maintenance, suitable for pre-grinding requirements of various materials.
Using 1400rpm speed regulation and 1.5 liters effective volume sand grinding basket, rapid dispersion and grinding are achieved through tensile shear and Impact between sand and material, and the operation is simple.
Adopting the principle of planetary motion, the particle size of grinding discharge can reach 0.1 μm, supporting dry grinding, wet grinding, vacuum grinding and other methods, with four stations and 800rpm Rotation speed, safe and stable operation.
Suitable for medium and high viscosity materials, using bottom open turbine structure with strong suction pump effect, grinding medium diameter 0.8-2 mm, variable frequency speed range 0-1440rpm, equipped with chill down heating jacket to control material temperature.
With dry grinding and wet grinding dual test function, friction Frequency four-speed adjustable (21/42/85/106cpm), support 0~ 99999 automatic shutdown, in line with JIS-5071-1 and other standard requirements.
Set dispersion and sand grinding functions in one, complete two processes in a single container, speed range 130~ 3000rpm, grinding basket size Φ 80x60mm, high efficiency and easy to clean.
