Constant pressure ensures uniform sampling, suitable for a variety of powder material testing, implementation of GB9087-88 and other standards, improve sampling accuracy and conformity.
Manual pressure control pressure holding operation is simple, electronic pressure holding device reduces mechanical abrasion, pressure range 0~ -90kPa, accuracy +/- 0.1kPa, Organic Glass sealing barrel wall thickness 15mm to enhance compressive strength.
Precision combination of cutting edge to ensure that the sample edge flat, especially for ring pressure test design, can cut standard samples, easy to operate, cutting effect is good.
Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
Using high elasticity standard rubber and denim for extrusion test, extrusion pressure 10-120kgf adjustable, Test speed 5-30 times/minute, to meet the requirements of YD/1539-2006 standard.
The pressure column and ball joint structure are used to ensure that the test surface is close, the pressure column mass is 250g, the bottom surface diaMeter is Φ 50 +/- 1mm, and it is equipped with 100g to 500g weight, which can simulate the contact performance of coatings under different pressure conditions.
The 0-16bar positive pressure method is used to test, which avoids the low pressure limit. The sealing situation can be judged by observing the leakage or pressure drop by inflation and pressure. Sensitivity is high and the reading is accurate.
Fully automatic test with microcomputer control, pressure range 0~ -90kPa accuracy +/- 0.1kPa, equipped with 15mm thick Organic Glass sealing barrel and precision pneumatic components, support automatic constant pressure air replenishment and multi-point pressure calibrating.
Touchscreen control, automatic constant pressure gas to ensure that the experiment in the preset vacuum, Vacuum Level range of 0~ -90KPa, a key operation automatically end the test, stable and durable performance.
Adopting oil-free piston technology, the working noise is only 62dB, equipped with a 50L gas storage Tank, the pressure switch automatically controls start and stop, and supports 5-8Bar pressure range adjustment to ensure stable air supply.
DiaMeter 20mm specification, starting pressure 0.7MPa, maximum pulling pressure up to 24MPa, suitable for a variety of drawing Testers, providing stable adhesion detection support.
With oil-free piston design, the exhaust pressure is 8 Bar, the exhaust volume is 300 L/min, and the noise is only 62 dB. It is equipped with a 50L gas storage Tank and automatic pressure switch control to ensure continuous and stable air supply.
Using electric pressure system, the printing pressure is adjustable from 0 to 2mm, the speed range is 0 to 80 Meters, low accuracy overprinting is supported, and the computer program control operation is stable.
Adopt servo electric printing pressure system, printing pressure 0-4mm automatic adjustment, printing speed 0-100 Meters can be set, support low accuracy overprint, simulate Gravure Printing drawdown blade Installation method, easy to detect inks.
