Konig and Persoz swing bars are used, Konig swing period is 1.4s, Persoz swing period is 1s, and the number of swing angles is automatically recorded, which is suitable for accurate determination of paint film Hardness.
Hand type easy to operate, load 1000g, standard 6B-6H pencil, suitable for film hardness testing, test temperature 23 +/- 2 ℃ and Humidity 50 +/- 5% environment.
Manual measurement of paint film Hardness, load 1000g, test angle 45 °, three-point contact with the tested surface design, suitable for inspection in any direction.
Manual measurement of paint film Hardness, load 500g, test angle 45 °, can be inspected in any direction, three points contact with the measured surface.
Three-point contact design ensures 45 ° stability testing angle, equipped with 6B-6H pencil and 500g to 1000g adjustable load, manual push to achieve accurate film Hardness identification.
Equipped with 200 +/- 0.2g and 500 +/- 0.1g two swing bars, can measure the film damping time, reflect the surface Hardness through swing attenuation, support different standard test requirements.
Hand crank type is easy to operate, load 1000g +/- 1g, scratch speed about 1mm/s, test angle 45 °, standard 6B-6H pencil, in line with a number of international standards, through the pencil Hardness grade to accurately evaluate the scratch performance of the paint film.
Using Konig swing Rod, mass 200g, swing period 1.4 +/- 0.02s, can swing 250 +/- 10s on flat Glass, suitable for coating damping test, accurate measurement Hardness change.
It can be equipped with 200 +/- 0.2g and 500g swing Rods, providing 1.4 +/- 0.02s and 1 +/- 0.001s swing cycles respectively, and accurately determines the film Hardness through damping time to adapt to different coating resilience and viscosity characteristics.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Using two-wheel and refill three-point contact design, refill and test surface to maintain an angle of 45 degrees, equipped with 750g weight load, by pushing the Tester can accurately determine the film Hardness value, easy and reliable operation.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Using two-wheel and refill three-point contact structure, refill and test surface to maintain an angle of 45 degrees, equipped with 1000g weight, by pushing the Tester to accurately determine the film Hardness value, easy and reliable operation.
The scribing needle is used to act vertically on the film, the load range is adjustable from 0-2000g, the minimum increment is 50g, and the diaMeter of the steel ball is 1mm, which can accurately determine the minimum weight required to cut the paint film.
Manual measurement of film Hardness, test angle 45 °, load 1 +/- 0.05kg, three-point contact with the measured surface, suitable for inspection in any direction.
