The stainless steel pendulum pipe is used to achieve +/- 180 degree swing, equipped with 25 water spray holes and 1-4 rpm adjustable turntable, supporting 50-100kpa water pressure adjustment, and the test water can be recycled without additional waterproof treatment.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
Impact accuracy is ensured by double-tube guide structure, the maximum impact energy can reach 320J, the impact height error is controlled within +/- 2mm, and the automatic hammer lifting function is equipped to prevent secondary impact.
Constant pressure ensures uniform sampling, suitable for a variety of powder material testing, implementation of GB9087-88 and other standards, improve sampling accuracy and conformity.
With +/- 180 degree swing tube swing and 1~ 4 rpm adjustable sample holder speed, support 50~ 100kpa water spray pressure and 99 hour time setting, and use stainless steel structure to achieve accurate water test.
Using single chip control technology, the impact height can be preset and automatically positioned, the accuracy is up to +/- 1mm, and the secondary impact can be automatically prevented. The mass range of the hammer body is 0.25-15 kg, and the two test methods of passing method and layer method are supported.
Manual pressure control pressure holding operation is simple, electronic pressure holding device reduces mechanical abrasion, pressure range 0~ -90kPa, accuracy +/- 0.1kPa, Organic Glass sealing barrel wall thickness 15mm to enhance compressive strength.
Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
Using high elasticity standard rubber and denim for extrusion test, extrusion pressure 10-120kgf adjustable, Test speed 5-30 times/minute, to meet the requirements of YD/1539-2006 standard.
The pressure column and ball joint structure are used to ensure that the test surface is close, the pressure column mass is 250g, the bottom surface diaMeter is Φ 50 +/- 1mm, and it is equipped with 100g to 500g weight, which can simulate the contact performance of coatings under different pressure conditions.
Fully automatic test with microcomputer control, pressure range 0~ -90kPa accuracy +/- 0.1kPa, equipped with 15mm thick Organic Glass sealing barrel and precision pneumatic components, support automatic constant pressure air replenishment and multi-point pressure calibrating.
Touchscreen control, automatic constant pressure gas to ensure that the experiment in the preset vacuum, Vacuum Level range of 0~ -90KPa, a key operation automatically end the test, stable and durable performance.
The 0-16bar positive pressure method is used to test, which avoids the low pressure limit. The sealing situation can be judged by observing the leakage or pressure drop by inflation and pressure. Sensitivity is high and the reading is accurate.
Adopting oil-free piston technology, the working noise is only 62dB, equipped with a 50L gas storage Tank, the pressure switch automatically controls start and stop, and supports 5-8Bar pressure range adjustment to ensure stable air supply.
