Travel 0-1.25 mm, measurement error +/- 1HAM, pressure at the end of the needle 324-764mN, suitable for thin rubber samples with a thickness of 1.5mm or more, and can be used with a fixed load measuring rack.
Travel 0-1.25 mm, measurement error +/- 1HAM, suitable for thin rubber samples with a thickness of 1.5mm or more. Sensitivity is high, and it needs to be used with a constant load measuring rack to ensure Precision.
Battery-free, durable rare earth cobalt magnets, Measurement range 0 to 200 μm, accuracy +/- 1 µm (within 20 µm), with audible cues and wear-resistant carbide Probe.
Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
Echo-echo technology implementation of 0.15mm ultra-thin part measurement, resolution of 0.001mm, can penetrate 0.5mm coating measurement substrate Film thickness, support sound speed calibrated and difference mode settings.
Measurement range 0-10mm, accuracy ≤ 0.02mm, using Dial reading, Graduation 0.01mm, upper probe diaMeter 6mm plane, suitable for workshop site and laboratory thickness measurement.
Using 7.5MHz High Frequency Probe, Measurement range 0.7~ 50mm, suitable for thin-walled and small arc surface workpieces, the lower limit of pipe measurement is Φ 25 * 1.2mm, strong adaptability.
Using clutter flying technology implementation of 0.15mm ultra-thin parts measurement, the highest resolution of 0.001mm, support through coating measurement and Bluetooth communication, with voice broadcast and LED backlight function.
Dedicated to Coating thickness Gauge calibrating, ensure accurate thickness measurement, suitable for F type equipment, improve Reliability.
Frequency 10MHz, Measurement range 0.65~ 20mm, suitable for thin-walled and small curved surface workpieces, the lower limit of pipe measurement Φ 10 * 1.0mm.
Using clutter flying technology implementation of ultra-thin parts measurement, minimum Film thickness of 0.15mm, the highest resolution of 0.001mm, with two Measurement modes and through the coating measurement function, equipped with 15MHz single crystal delay probe.
Suitable for thin samples with a thickness of less than 6mm, featuring multiple testing modes such as real-time, peak, automatic timing, and average value. It can be connected to a computer for data management and curve analysis.
Dial indicator reading is accurate, with dual unit display without conversion, maximum Measured value 100N, Indication Error +/- 1%, can freely switch peak holding and real-time load value, suitable for all kinds of fixture installation.
Dial indication for easy reading, with dual unit display function without conversion, can freely switch peak holding and real-time value mode, Measurement accuracy of +/- 1%, push-pull Rod Travel 10mm, suitable for all kinds of fixture installation.
Measurement range 0.0~ 500μm, error +/- (0.3μm + 2%), ultra-small probe suitable for nails, bolts and other small workpiece thin platings measurement, with multi-point calibrating and statistical functions to ensure high Repeatability and Stability.
