Overview
The LANDTEK VM6360 Vibration Meter is a Portable instrument designed for on-site measurement of various mechanical vibrations, designed to provide data support for quality control, runtime and preventive maintenance of equipment. It uses a high-performance Piezoelectric Acceleration Sensor, communicates with a PC via USB, RS-232 or Bluetooth, and has AC signal output.
Features
1. Frequency range is wide, up to 10Hz~ 10KHz in Acceleration mode.
2. Compliant with international standard ISO2954, for periodic motion measurement, detection of mechanical imBalance and deviation.
3. Provide USB, RS-232 and Bluetooth Data output methods for easy communication with PC.
4. Select a high-performance accelerometer to achieve accurate and reproducible measurement.
5. With AC signal output, it is convenient for auscultation and recording.
6. Optional headphones can be used as a stethoscope.
7. With metric/imperial unit conversion function.
8. Equipped with battery low voltage prompt function.
Principle
The vibration meter uses piezoelectric Acceleration Sensor to convert mechanical vibration signals into electrical signals. The electrical signals are processed and analyzed internally, and finally the vibration amount is displayed on the LCD screen with displacement, speed or Acceleration value. At the same time, the measurement results can be output to external devices through the Interface.
Applications
On-site mechanical vibration measurement, quality control, equipment operation status monitoring, preventive maintenance
Steps
1. Install 4 AA batteries and pay attention to the battery polarity.
2. According to the measurement requirements (displacement, speed, Acceleration) and the measured object Frequency range, select the appropriate Measurement mode and range.
3. Hold the Vibration Sensor Probe vertically and firmly against the measured point.
4. Read the stable measurement value on the LCD screen.
5. For data recording or analysis, data output to PC via USB, RS-232 data cable or Bluetooth connection.
Notice
Please ensure that the Sensor is in good contact with the surface to obtain an accurate reading.
* Operating Environment temperature should be between 0~ 50 ℃, relative humidity below 90% RH.
* Pay attention to the battery power, and replace it in time when the voltage is low to prevent measurement errors.
* When selecting the "x10" gear in Acceleration mode, it is dedicated to bearing inspection. Frequency range is 10Hz~ 10KHz.
* The instrument should avoid severe impact and keep clean and drying.
