Overview
TAISITE MFLC-2/12P ceramic muffle furnace is a laboratory heating equipment with a maximum temperature of 1200 ° C. It adopts an integrated lightweight and compact design. The furnace is made of vacuum formed polycrystalline mullite fiber and is heated on three sides with special nickel-chromium-aluminum alloy heating wire to ensure good Temperature uniformity. The equipment is equipped with a High Accuracy imported programmable temperature controller and K-type Thermocouple to achieve precise temperature control.
Features
1. Integrated design, lightweight and compact structure.
2. Vacuum forming polycrystalline mullite fiber furnace, good thermal insulation effect.
3. Special alloy heating wire three heating, Temperature uniformity.
4. Open the door and power off, reset delay safety design.
5. Double shell air insulation, low surface temperature.
6. Equipped with an exhaust device, which is conducive to ashing.
7. High Accuracy Microcomputer PID Temperature Controller Combined with Precision Sensor, Temperature Control accuracy +/- 1 ℃.
8. Dedicated function keys enable temperature setting, making operation convenient.
9. With over-lift alarm, deviation correction, menu lock, over-lift preventer and other auxiliary features.
10. Parallel side open furnace door design keeps the hot end away from the operator.
Principle
The muffle furnace uses a microcomputer PID Control system to precisely control the Power output of the nickel-chromium-aluminum alloy heating element according to the set temperature program to heat the furnace. K-type Thermocouple monitors the temperature in the furnace in real time and feeds it back to the temperature controller to form a closed-loop control to ensure that the temperature is stable at the set value. The three-sided Heating mode and the excellent thermal insulation performance of the polycrystalline mullite fiber furnace achieve rapid heating and good Temperature uniformity in the furnace.
Applications
Material ashing, sample burning, material heat treatment, laboratory high temperature experiment
Steps
Connect the power supply (AC220V/7A 50/60Hz).
2. Set the target temperature or program Linear dispersion by tapping the five buttons for digital display setting.
3. Set the timing time as required (0 to 999.9 hours).
4. Start the equipment to start heating operation.
5. During operation, the real-time temperature can be observed through a dual-row LED digital display.
6. In the program operation mode, the preset 4 Linear dispersion 40-step program can be executed.
7. After the experiment, wait for the furnace to chill down before opening the door to take out the sample.
Notice
• The device will automatically power off when it opens the door. There is a delay in power back after closing the door. Please pay attention to safety.
• There may still be residual temperature on the surface of the furnace body. Please use special tools during operation to avoid burns.
• Do not heat flammable, explosive or toxic gases in the furnace.
• Equipment is equipped with a vent hole (outer diameter φ 22), please ensure that the Operating Environment is well ventilated.
Equipment equipped with overcurrent leakage protection switch, in case of tripping, please check the line and load.
When performing temperature correction or function settings, please pay attention to the menu lock status.
• Do not operate beyond the maximum operating temperature of the device (1200 ° C).
• Before moving or cleaning equipment, be sure to disconnect the power and make sure the furnace is completely chilled down.
