Overview
KESIONOTS KS-HD408LB low/high temperature test chamber, also known as Environmental Test Chamber, is suitable for high temperature and low temperature Reliability test of industrial products. The equipment is used for inspection of electronic and electrical, automobile and motorcycle, aerospace, ship weapons, colleges and universities, R & D institutions and other related products under high temperature and low temperature (alternating) cycle changes of parts and materials performance indicators, serving product design, improvement, identification and inspection, such as aging test.
Features
1. Temperature range is wide, up to -60 ℃ to 150 ℃.
2. Temperature control accuracy, analytical accuracy of +/- 0.1 ℃, control accuracy +/- 1 ℃.
3. Using high-quality materials, the outer box is high-grade cold-rolled sheet paint, and the inner box is stainless steel.
4. Equipped with well-known brand controller (Korean "TEMI" or Japanese "OYO" optional) and Compressor ("Taikang" or German BITZER optional).
5. Safety protection device with multiple, such as no fuse switch, Compressor overload protection, refrigerant high voltage protection, over temperature protection.
6. Complete standard configuration, including viewing window, test hole, box light, Shelf, etc.
Principle
The low/high temperature test chamber simulates and precisely controls the required extreme temperature environment in a closed box through the refrigeration system (Air-Cooled/single-stage Compressor or wind, Water-Cooled/double-stage Compressor) and heating system. Control system drives the refrigeration or heating elements according to the setting program, so that the temperature in the box changes within the specified range of domestic circulation to test the performance and Reliability of the sample under temperature stress.
Applications
Electronics and electricians, automobiles and motorcycles, aerospace, ships and weapons, colleges and universities, R & D institutions
Standards
GB2423.1、GB2423.2、GJB150.3、GJB150.4、IEC、MIL
Steps
1. Place the sample to be tested correctly on the Shelf in the box.
2. Close the door and make sure the sealing is good.
3. Set the required temperature program (such as Temperature range, rate of change, holding time, etc.) through the controller.
4. Start the equipment, the test chamber starts to run, and the temperature is raised and cooled according to the set program.
5. During the test, the sample status can be observed through the viewing window.
6. After the test, the equipment is stopped according to the program or manually. After the temperature in the box approaches the Ambient Temperature, open the box door to remove the sample.
Notice
• Equipment power supply needs to match requirements (220VAC +/- 10% 50/60Hz or 380VAC +/- 10% 50/60Hz).
When placing the sample, ensure that the air duct is not blocked to ensure uniform temperature in the box.
• During the test, do not open the door frequently to avoid affecting the temperature stability and test results.
When the equipment is running, please pay attention to its operating status. If there is an alarm, it needs to be dealt with in time.
• Perform regular equipment maintenance to ensure that the chilled down system is working properly.
When taking out high or low temperature samples, it is necessary to take good protection to avoid burns or frostbite.
