With a 5/10 station design and room temperature range, multiple samples can be tested simultaneously, and the adhesion and durability performance can be accurately evaluated through the suspension weight measurement of the displacement or complete disengagement time.
Using 2000g +/- 5g roller load and 300mm/min rolling speed to ensure that the adhesive tape sample is flat and evenly adhered to the standard substrate, in line with CNS-11888 and PSTC-8 design standards.
Equipped with 10-station synchronous test capability, 1000g weight and 1-999999 minute Timer, using SUS #304 steel plate to ensure test accuracy, and automatically recording tape peeling time.
With 5 groups of independent testing capabilities, the temperature control range is from room temperature to 70 ° C, and the hot air circulation method is used to ensure Temperature uniformity.
Measured value 500N, suitable for tape, PCB, adhesive tape and other materials disbonding force test, supporting the Force Gauge test bench.
10 station design can carry out multiple sets of tests at the same time. Temperature range RT +~ 250 ℃, hot air circulation to ensure uniform temperature. With over-temperature and electric overload automatic power-off protection, improve operation safety.
Tack testing to assess adhesion by measurement of displacement or peeling time under specified weight. With thermostatic test chamber, multi-national standards are supported and the operation process is clear.
The adhesive force of the tape is 4.3N/cm, and the principle of cross-cut method is adopted, which is suitable for adhesion testing. The performance is stable and non-degumming, and the test results are accurate and reliable.
Measurement accuracy of 0.007mm, Graduation of 0.001mm, probe diaMeter Φ 5mm, maximum measurement depth 45mm, suitable for on-site rapid thickness detection.
Equipped with 1000g weight and 1~ 999999 minute Timer, using SUS #304 steel plate to ensure test accuracy and meet a number of national standards.
The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
Precision ball screw drive and double rail design, Force Measurement range 0.03-200 N, Accuracy grade 0.5, support a variety of unit selection and intelligent calculation test results, equipped with micro printer and overload protection function.
Manual control of holding pressure is easy to operate, 15mm thick Organic Glass sealing bucket enhances compressire strength, Vacuum Level range -90~ 0kPa, resolution accurate to 0.1kPa, built-in time display automatic timing clear.
With 6 test stations can synchronize multiple sets of tests, High Accuracy proximity switch and laser cross-cut test board, timing range of 9999h59min59s, automatic Timing function to ensure accurate and reliable data.
Six-station synchronous test, timing accuracy of 99 hours 59 minutes 59 seconds, using imported proximity switch and laser cross-cut test board to ensure accurate and reliable data, with automatic timing and anti-data loss function.
