The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
Equipped with 6 strokes and 305mm Travel, it can automatically record four stages of the drying process continuously, and intuitively display the curing state of the paint film through the straight track, and the measurement error is controlled within +/- 4%.
Using 200 +/- 0.2 g weight and 1 square centiMeter bottom area design, the drying process of the paint film was accurately determined by the cotton ball method to distinguish between surface drying and actual stages in drying.
The instrument adopts a six-pin design, forms plow marks on the paint film through uniform linear motion, and automatically displays the drying process according to the change of traces. The measurement error is controlled within +/- 4%, and supports three time settings of 6h, 12h and 24h.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
The circular track is used to automatically record the film drying process continuously, equipped with 4 kinds of specifications to choose from, the track diaMeter is 100mm, and the measurement error is +/- 0.5%, which can intuitively analyze the stages in drying state.
Using nylon mesh and weight combination test, equipped with 200g to 1000g multi-specification weight, can accurately detect the surface imprint condition after coating drying, in line with international standards.
Nominal Mass 200 +/- 0.2g, bottom area 1cm ², using computer information acquisition processor to complete the experimental process to ensure accurate and reliable data.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0-10.5 mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
The equipment uses 200 +/- 0.2g weight, sample size 50 * 120 * (0.2~ 0.3) mm, can accurately determine the surface and actual drying time, in line with national standards.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
The pressure range of the probe is 50~ 250N, the diaMeter of the rubber probe is 40mm, and the degree of paint film chalking is evaluated by comparing the imprint of the photo paper with the standard sample, which is suitable for the detection of various environmental factors.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
