Adopt oblique block to adjust the gap, good self-cumbersome and high adjustment accuracy; Roller cylindricity ≤ +/- 2um, Hardness up to HRC62 and hard chrome plating to prevent rust; Electric rolling can be reversed, and the film thickness and speed can be adjusted.
Equipped with three sets of independent rollers, load accuracy of +/- 5g, rolling speed of 300mm/min, can accurately simulate the bonding effect of materials under different pressure conditions, rubber wheel Hardness Hs80 +/- 5 to ensure test conformity.
The dual-station design can simultaneously carry out two sets of tests, the roller load is 2000g +/- 5g, and the rolling speed is 300mm/min, which conforms to CNS-11888 and PSTC-8 standards to ensure uniform preparation of the sample.
Using 2000g +/- 5g roller load and 300mm/min rolling speed to ensure that the adhesive tape sample is flat and evenly adhered to the standard substrate, in line with CNS-11888 and PSTC-8 design standards.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Brushless DC motor, Rotation speed 100rpm, support positive and negative rolling mode, compatible with different size testtube, low noise and maintenance-free operation, suitable for long-term continuous operation.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Rotation speed 100rpm, low noise and maintenance-free; support positive and negative rolling swing mode, compatible with different size testtubes, gentle rolling to ensure sample safety, continuous operation and reliability.
Brushless DC motor, Rotation speed 100rpm, low noise maintenance-free, support normal and negative two rolling modes, compatible with different size testtube, gentle rolling to ensure sample safety.
Using 160 line metal anilox roller and rubber roller combination, print width 70mm, suitable for inks proofing, wet film thickness and the number of lines inversely proportional, proofing authenticity and easy to operate.
DC brushless motor, Rotation speed 100rpm, support positive and negative rolling mode, gentle mixing and compatible with a variety of testtube sizes, suitable for long-term continuous operation, low noise and maintenance-free.
Uniform Spreader with dual roller structure, 160 lines/inch anilox roller precisely controls film fineness, metal plating anilox roller ensures durability and supports multi-material Spreader testing.
Using 200LPI anilox roller and 70mm print width, metal anilox roller and rubber roller combination, the handle is made of stainless steel, suitable for a variety of inks Spreader and good sample repRoducibility.
Adopt horizontal three-roller extrusion grinding, roller clearance hand adjustment, maximum processing viscosity 3000000cps, roller can be cooled down water temperature control, fineness control precision, suitable for a variety of viscosity materials.
The metal plating anilox roller with 120 lines/inch quadrilateral pyramid mesh hole is used to achieve uniform Spreader with rubber roller, and the print width is 70mm, which is suitable for film effect testing of various liquid materials.
