Maximum load 0.5KN, specially designed for sharp angle samples, providing stable clamping force, avoiding sample slippage or damage, and improving test accuracy and Repeatability.
With a diaMeter of 0.75mm and a radius of 0.375mm, the test head meets Bosch and Volvo standards and provides accurate scratch hardness testing.
The 0.5mm/R = 0.25 test head meets Opel, Volvo and van Laar industry standards to ensure accurate scratch hardness measurement.
The nib is 1mm in diaMeter, equipped with three springs covering the 0-30N pressure range, and the tungsten carbide tip can leave visual marks to evaluate surface Hardness, ergonomically designed non-slip grip.
The test head has a diaMeter of 1.0mm and a spherical radius of 0.5mm, which meets the Opel, Volvo, van Laar industry standards and can accurately evaluate the scratch resistance of coatings.
Fiber wear-resistant tip design is not easy to deform, Test accuracy of +/- 0.5 dyne, 2-4 seconds after drawing the line to observe the results, suitable for a variety of materials Surface Energy detection.
Fiber wear-resistant pen tip design to ensure smooth and durable ink, accuracy of +/- 0.5 dyne, can quickly detect a variety of materials Surface Energy, sealing pen cap extended shelf life.
Fiber wear-resistant tip has a long service life, Accuracy of +/- 0.5 dyne, and the results can be observed 2-4 seconds after drawing. It is suitable for surface energy testing of various substrates.
Equipped with fiber wear-resistant tip, accuracy of +/- 0.5 dyne, 15ML large-capacity ink design, fast test, 2-4 seconds results, suitable for a variety of surfaces.
Using 0.5mm tungsten carbide tip, the spherical test point can scratch 2000 90mm long scratches without damage after durability test, the design is comfortable and stable, and it is suitable for regular interval scratch operation in corrosion test.
Imported special steel pressure needle, Hardness and long life, range 0-20HW, can directly read the Hardness value, suitable for on-site rapid testing, Stability and portability.
Impact energy 11mJ, Impact device mass 50g, ball head diaMeter 3mm, Hardness measurement hole or cylinder, suitable for a variety of metal hardness of materials testing.
It adopts 45 ° fixed angle design, loads 1000g +/- 10g, and evaluates Hardness by scratching coatings with different Hardness pencils, which is easy to operate and accurate.
Compact and lightweight can be operated with one hand, without support and testing experience, the test range is equivalent to brinell hardness 25~ 150HB, can measure a variety of Hardness scales and has MAX Maximum hold and average calculation functions.
Adopt four-link mechanism to ensure a constant 45 ° test angle, equipped with 500/750/1000g adjustable load, accurately determine film Hardness through different Hardness pencil scratches, meeting standard test Environmental requirements.
