SUS304 stainless steel inner box and double insulation structure, equipped with 360 degree swirl/spin sample holder and precise ozone concentration control, temperature fluctuation +/- 0.5 ℃, support static dynamic tensile test, suitable for rubber durability research.
Adopt silent ozone generator and UltravioletDetector, ozone concentration control accuracy +/- 2pphm, support static tensile and dynamic tensile test, Temperature Uniformity ≤ 2 ℃ to meet a variety of test conditions
Adopt independent ozone concentration controller for long-term stable non-drift, equipped with high voltage silent discharge tube ozone generator, concentration range 10~ 1000pphm, Temperature Fluctuation +/- 0.5 ℃, support static tensile specimen and sample rack speed 1~ 2rpm.
Imported stainless steel liner and independent ozone concentration controller, temperature control accuracy of +/- 0.5 ℃, equipped with static tensile fixture and rotational speed adjustable sample rack, support long-term stable operation.
High Accuracy PID control technology, temperature fluctuation +/- 0.5 ℃, equipped with independent ozone concentration controller long-term stable non-drift, support static tensile specimen and program operation mode.
Using electric heating wire to achieve rapid and uniform heating, equipped with 360 degree swirl/spin sample holder and imported concentration Analyzer, support 10-1000PPhm ozone concentration range, temperature fluctuation is only +/- 0.5 ℃.
Using electric heating wire to achieve rapid and uniform heating, equipped with 360 degree swirl/spin sample holder and imported concentration Analyzer, support 10-1000PPhm ozone concentration range, Temperature Fluctuation control within +/- 0.5 ℃.
Using electric heating wire to achieve rapid and uniform heating, equipped with 360-degree swirl/spin sample holder and 12-16mm/s gas flow rate, support 0-9999 hours time setting, with leakage overtemperature multiple safety protection.
The heating wire is used to achieve rapid heating, the temperature fluctuation is only +/- 0.5 ℃, equipped with 360 degree swirl/spin sample holder and imported concentration Analyzer, supports dynamic static test mode, and meets a variety of test needs.
Using UV absorption principle to detect ozone, range 0-2.00 mg/L can be selected to 20.00mg/L, accuracy error ≤ +/- 3% F. S, Response Time ≤ 30 seconds, support flameproof design and a variety of signal output, suitable for complex industrial environment.
Using heating wire and PT100 temperature transducer, Temperature Fluctuation +/- 0.5 ℃, support 0~ 999H light time setting, 360 degree swirl/spin sample holder and imported concentration Analyzer to ensure test accuracy.
The motor is used to drive the top edge to rise, the edge length is 150mm, and the rising rate is 3mm/min, which can accurately test the dynamic anti-cracking performance of the material against the crazing expansion of the substrate, and the operation is light and stable.
With 0~ 100ppm ozone detection range and T90 ≤ national standard Response Time, support remote paraMeter configuration and zero automatic correction, explosion-proof IP66 protection is suitable for harsh industrial environments.
Equipped with automatic centering device to avoid eating unilateral problems, maximum load 50Kg, Test speed range 0-100mm/min, support dynamic Impedance test and a variety of damage strength test.
Dynamic Impact is achieved with a two-box mobile structure, with a cold and heat conversion time of no more than 10 seconds and a temperature recovery time of less than 5 minutes. It is equipped with HFC environmentally friendly refrigerant and a binary ultra-low temperature freezing system, meeting the requirements of many international testing standards.
