The motor is used to drive the top edge to rise, the edge length is 150mm, and the rising rate is 3mm/min, which can accurately test the dynamic anti-cracking performance of the material against the crazing expansion of the substrate, and the operation is light and stable.
Equipped with automatic centering device to avoid eating unilateral problems, maximum load 50Kg, Test speed range 0-100mm/min, support dynamic Impedance test and a variety of damage strength test.
Using Dynamic Low Temperature Nitrogen Adsorption Method and High Sensitivity Sensor, the test range from 0.0005m ²/g has no upper limit, the repeatability error ≤ +/- 3%, and the single sample test is completed in about 3 minutes.
With 2-level accuracy and +/- 2% Indication Error, it supports three test modes of real-time tracking, peak holding and first peak, and can store 99 sets of data and automatically calculate statistical values.
With 1 level accuracy and +/- 1% Indication Error, it supports three test modes of real-time torque tracking, peak holding and first peak, and can store 99 sets of data and automatically calculate statistical values.
With 1 level accuracy and +/- 1% Indication Error, supports automatic conversion of three units and 99 sets of data storage, can set peak hold time and upper and lower limit alarms, equipped with dedicated software for data analytics and Linear dispersion display.
Can simultaneously detect dynamic and static Coefficient of Friction, force range 0~ 5N, accuracy level 1, support microcomputer control and micro printer output test report.
With +/- 2% indication relative error and 0.1N.m resolution, it supports three test modes of real-time tracking, peak holding and first peak, and can set upper and lower limits for comparison and automatically calculate statistical values.
Dual gas source dynamic Gas chromatography, CG, 4 station design test efficiency, each sample only 5-7 minutes, measurement error ≤ +/- 1%, high Sensitivity Detector to ensure accurate and reliable data.
SUS304 stainless steel inner box and double insulation structure, equipped with 360 degree swirl/spin sample holder and precise ozone concentration control, temperature fluctuation +/- 0.5 ℃, support static dynamic tensile test, suitable for rubber durability research.
It can automatically measure the dynamic and static Coefficient of Friction at the same time, using high-precision ball screw drive, the total error of the force measurement system is less than +/- 2%, and the micro printer can print multiple sets of results and the average value.
Based on the national standard design, the static Coefficient of Friction and the dynamic Coefficient of Friction can be measured simultaneously, with a test accuracy of up to 0.001N, equipped with High Accuracy Sensor and special drive system to ensure smooth operation and accurate results.
Weighing range 0-310g, Readability 1mg, with four-level shockproof and dynamic temperature compensation functions, support counting, percentage weighing and RS232 interface to connect external devices.
Heating power 800W, speed range 0-2600 rpm, support vacuum reaction and pressure reaction for a long time stirring, with durable magnetic steel and PTFE stirrer.
Using electronic Sensor technology, accuracy level 1, resolution up to 0.001N.m, support three automatic unit conversion and three test modes, can store 99 sets of data and automatically calculate statistical values
