The thickness of the pressurable steel plate Aluminum Panel is 0.2~ 1.5mm, the weight of the whole machine is 50kg, and the compact shape is only 300 * 300 * 190mm, which meets the NCCA standard T-Bend test method.
Support 0.1-1 steel plate and 0.1-2 Aluminum Panel test, can complete 0T to 1T multi-stage bending, equipped with pliers pressing device and tape adhesion inspection function, to meet the standard bending test process.
The equipment can perform a 45 ° bending test, support 0.5~ 1.0mm plate thickness, equipped with Travel ≥ 10mm flattening mechanism, suitable for accurate testing of coating flexibility.
Measure the surface of paint film and putty film and the actual drying time, in line with GB/T1728 standard, the weight of the Tester is 200g, and the weight of the bottom area is 1cm ².
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Using 200g weight and 1cm ² bottom area design, in line with GB/T 1728 standard, through the filter paper test method to accurately determine the film surface drying and practical drying time, easy to operate, reliable results.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
Hand type easy to operate, load 1000g, standard 6B-6H pencil, suitable for film hardness testing, test temperature 23 +/- 2 ℃ and Humidity 50 +/- 5% environment.
The adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel ≥ 80mm. The integrity of the paint film was evaluated by seven grades, and the operation was simple and conformed to the GB/T1720 standard.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0-10.5 mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Used for paint film hiding power measurement and reflectance measurement, indication interval 0-100, Repeatability 0.3%, in line with national standards GB/T13452.3, GB9270, GB5211.
The test bending angle is less than 45 degrees, suitable for steel plate thickness 0.5~ 1.0mm and Aluminum Panel thickness 0.5~ 2.0mm. The gear pair and crank lifting mechanism are used to achieve T-shaped bending, which is easy to operate.
The pressure range of the probe is 50~ 250N, the diaMeter of the rubber probe is 40mm, and the degree of paint film chalking is evaluated by comparing the imprint of the photo paper with the standard sample, which is suitable for the detection of various environmental factors.
