Constant pressure ensures uniform sampling, suitable for a variety of powder material testing, implementation of GB9087-88 and other standards, improve sampling accuracy and conformity.
The equipment operates under vacuum or pressure conditions, with a processing viscosity of 10000MPas, Operating temperature of 170 ° C, equipped with anchor type screw scraping wall stirring slurry and high shear homogeneous Mulser, supporting Multi-ParaMeter measurement such as material temperature and pressure.
With oil-free piston design, the exhaust pressure is 8 Bar, the exhaust volume is 300 L/min, and the noise is only 62 dB. It is equipped with a 50L gas storage Tank and automatic pressure switch control to ensure continuous and stable air supply.
Manual pressure control pressure holding operation is simple, electronic pressure holding device reduces mechanical abrasion, pressure range 0~ -90kPa, accuracy +/- 0.1kPa, Organic Glass sealing barrel wall thickness 15mm to enhance compressive strength.
Precision combination of cutting edge to ensure that the sample edge flat, especially for ring pressure test design, can cut standard samples, easy to operate, cutting effect is good.
Using electric pressure system and circular pressing operation mode, printing pressure 0-4mm, speed 0-100 Meters, adjustable scraper pressure and speed, support low accuracy overprinting and Color detection.
Using R2.5mm steel ball to apply 20N pressure, test at standard temperature for 60 minutes and then evaluate the thermal deformation performance of the material through measurement of Crane diaMeter, which is suitable for testing of various electrical components.
Using intelligent control pressure relief system, Measurement range 10~ 1600kPa, Indication Error ≤ +/- 0.5%, all-steel chain drive to improve Stability, real-time observation of test sample blasting process.
Adopting a two-stage design, the pumping speed is up to 60L/min, the ultimate pressure is 0.085MPa, and it can operate continuously for 24 hours without oil. The noise is lower than 50dB, and it has the dual function of positive and negative pressure, making it easy to maintain.
Using high elasticity standard rubber and denim for extrusion test, extrusion pressure 10-120kgf adjustable, Test speed 5-30 times/minute, to meet the requirements of YD/1539-2006 standard.
Adopting oil-free piston technology, the working noise is only 69 decibels, equipped with a 220L gas storage Tank to ensure stable air supply, the pressure switch automatically controls the start and stop between 5-8 Bar, and supports a large Flow rate output of 1000L/min.
The pumping speed is 60L/min, the ultimate pressure is > 0.085Mpa, the positive and negative pressure is dual-use, the oil-free operation, the noise is lower than 50dB, it can work continuously for 24 hours, and the maintenance is simple.
Measurement range 0~ 1000ml/min, pressure difference 0.1~ 2.0kpa, stainless steel end cap and pure copper valve anti-corrosion structure, built-in fixture to avoid rubber pad peeling, suitable for a variety of materials Air Permeability accurate test.
Adopting oil-free piston compression technology, the exhaust pressure is 8 Bar, the exhaust volume is 525L/min, and it is equipped with a 100L gas storage Tank and automatic pressure control. The noise is as low as 60dB to ensure a stable air supply.
The pressure column and ball joint structure are used to ensure that the test surface is close, the pressure column mass is 250g, the bottom surface diaMeter is Φ 50 +/- 1mm, and it is equipped with 100g to 500g weight, which can simulate the contact performance of coatings under different pressure conditions.
