Adopt Cr12 steel roll, Hardness reaches HRC52 °~ 58 °, Surface Hardness 0.2~ 0.1, easy to operate and easy to change color, suitable for fine grinding of material viscosity 30~ 8000cps range.
Using high frequency principle, Measurement range 0-60%, accuracy +/- 0.5%, Response Time 1 second, probe Sensor can penetrate deep into the material, support 20 kinds of material code selection.
Adopting three-roll extrusion friction grinding principle, Rotation speed 28-152rpm adjustable, fineness of grinding up to 15μm, Hardness HS70 ° above the surface of cold hard alloy steel roller, support water chilling down system, suitable for high viscosity material processing.
Using high frequency principle, measurement range 0-90%, resolution 0.1/0, Response Time 1 second, Sensor and host split design, Portable structure is suitable for on-site rapid detection.
Using high frequency principle, Measurement range 0-99.9%, resolution 0.1/0, Response Time 1 second, portable design can be deeply measured inside the material, backlit LCD display is clear and low power consumption.
With double Tank grinding and 1-30Hz vibration Frequency adjustment, support low temperature grinding protection heat sensitive material, discharge particle size up to 5~ 10μm, can process more than 10 samples at a time and grinding time only 1-3 minutes.
Three rollers are used to squeeze each other and friction at different speeds to achieve grinding. The roller material is cold hard alloy cast iron, with surface Hardness HS70 ° or more, and the fineness of grinding can reach 15μm, which is suitable for high viscosity material processing.
The use of diamond sanding needles can flatten the surface of the grinding wheel, improve the utilization rate of abrasive wheels, and is equipped with a water supply system to support wet grinding and dry grinding. The size of abrasive wheels is about 250 × 30 × 32mm, and the Rotation speed is 1400rpm.
The surface of three rollers is extruded and rubbed at different speeds to achieve grinding. The diaMeter of the roller is 65mm, and the fineness of grinding can reach 15μm. It is suitable for fine grinding and dispersion of high viscosity materials.
Double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support dry grinding, wet grinding and low temperature grinding, suitable for heat sensitive materials and minimal liquid nitrogen consumption.
The double Tank design is used to achieve high-throughput grinding, the vibration speed is adjustable from 60 to 1800rpm, and the discharge particle size is 5 to 10 μm. It supports dry grinding, wet grinding and low temperature grinding, and effectively protects the molecular structure of heat-sensitive materials.
Using double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support low temperature grinding protection of heat sensitive materials, a processing of more than 10 samples, grinding time only 1-3 minutes.
Using large-screen touch screen operation, intelligent control of grinding time and speed, grinding results are highly repeatability. The dual-Tank design supports high-throughput processing, and the discharge particle size can reach 5~ 10 μm. It is suitable for heat-sensitive materials and consumes very little liquid nitrogen.
Double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support low temperature grinding protection of heat sensitive materials, processing multiple samples at one time and high Repeatability.
Double disc independent control, stepless speed range of 50~ 1400rpm, can switch swirl/spin direction. DC brushless motor, low noise and strong torque, equipped with chilling down water pipe and grinding disc flushing function to prevent grinding material settling.
