Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
Equipped with 254nm and 365nm dual-wavelength ultraviolet light sources, it supports thin-layer analysis and paper-layer analysis, can identify fluorescent substances, and is equipped with a 200 * 50mm filter.
Using a formed pRoduction process, the film Film thickness is as thin as 4.6μm, the accuracy is up to 0.1 micron, and the effective Spreader width is 30cm. It can be used with an automatic Film Applicator and has the advantage of continuous wire.
Impact energy 2.7mJ, Impact device mass 75g, small damage to the measured surface, does not damage the hardened layer, suitable for measurement of small and thin parts, the minimum thickness of the specimen is 1mm, and the minimum depth of the hardened layer is 0.2mm.
Travel 0-1.25 mm, measurement error +/- 1HAM, suitable for thin rubber samples with a thickness of 1.5mm or more. Sensitivity is high, and it needs to be used with a constant load measuring rack to ensure Precision.
Travel 0-1.25 mm, measurement error +/- 1HAM, pressure at the end of the needle 324-764mN, suitable for thin rubber samples with a thickness of 1.5mm or more, and can be used with a fixed load measuring rack.
With a capacity of 2.5 liters, it adopts a single-layer structure design and is suitable for a variety of Power Dispersers to ensure efficient and stable material handling and easy operation.
Using metal layer plate structure, Temperature range -7~ 70 ℃, support 13 point temperature measurement, can simultaneously Spreader 6 samples, through drying air flow and layer temperature to achieve accurate film formation detection.
The continuous groove structure is made by extrusion process, the thickness of Spreader is 0 μ m, the total length is 400mm and the application width is 300mm. 304 stainless steel is easy to clean.
Made of stainless steel wear-resistant material, wet film thickness 41.1 μ m, application width 300mm, suitable for thin coating scraping test of soft materials, durable.
12.7Mm ultra-thin body and 250g lightweight design for easy portability; CAL-CHECK system can prompt ElectRode contamination and buffer information; Support 1000 sets of Data storage and USB interface transmission; Automatically identify ElectRode type and enter Measurement mode, suitable for a variety of environments.
Suitable for thin samples with a thickness of less than 6mm, featuring multiple testing modes such as real-time, peak, automatic timing, and average value. It can be connected to a computer for data management and curve analysis.
Using clutter flying technology implementation of 0.15mm ultra-thin parts measurement, the highest resolution of 0.001mm, support through coating measurement and Bluetooth communication, with voice broadcast and LED backlight function.
Frequency 10MHz, Measurement range 0.65~ 20mm, suitable for thin-walled and small curved surface workpieces, the lower limit of pipe measurement Φ 10 * 1.0mm.
The device can precisely control the film thickness of the ink layer of the color strip, and the ink injection amount is 0.0012g, which is used for ink contrast and color concentration detection.
