Equipped with Φ 1mm, Φ 0.75mm, Φ 0.50mm three probes and 0-30N spring pressure, using wheel handle design, can be quickly measured in plane and curved surface, no maintenance and anti-corrosion.
Suitable for flat or curved surface measurement, not limited by area, equipped with 0.5-1 test head and 0-40N spring pressure range, stable performance.
Measurement range 63-105HRF, suitable for Film thickness 0.4-6 mm workpiece, mechanical compression spring device durable and reliable, can directly read the Hardness value.
Impact energy 11mJ, Impact device mass 50g, ball head diaMeter 3mm, Hardness measurement hole or cylinder, suitable for a variety of metal hardness of materials testing.
Using mechanical compression spring design, Measurement accuracy 0.5HW, Film thickness 0.4-6 mm workpiece can be detected, and a variety of Hardness values can be obtained through the conversion table, which is suitable for on-site rapid detection.
Spring loaded indenter point design, measurement range 0-100 scale, weight only 1 pound 2 ounces, can quickly obtain hardness readings in any location, suitable for homogeneous material testing.
With 0.001N load Graduation and +/- 0.5% accuracy, support peak hold, data storage and three units of automatic conversion, can test the spring deformation and load relationship and output level signal.
Mechanical design is equipped with a compression spring device, Measurement accuracy 0.5HW, can detect Film thickness 0.4-13 mm material, through the Hardness conversion table to obtain a variety of Hardness value, high toughness table window glass impact resistance.
The pressure spring constant linear relationship, pressure needle Travel 0-2.5 mm, measurement error +/- 1HC, can be hand-held or installed measuring frame, suitable for shoe microporous hardness of materials testing.
Impact energy 11mN, Impact device mass 80g, suitable for measurement of slender narrow groove, can meet the needs of different shapes and sizes of workpiece Hardness detection.
The integrated structure is compact and portable, and the dual-coil technology is used to ensure good Repeatability and Measurement accuracy. The built-in Direction Sensor automatically compensates for errors, and supports a variety of Hardness standard conversions.
Impact energy 11mJ, ball head diaMeter 3mm tungsten carbide material, can measure a variety of metal hardness of materials, Che diaMeter minimum 0.35mm, suitable for conventional Hardness testing needs.
Suitable for soft rubber, thermal plasticity resilience and extremely soft plastics, Hardness Measurement range < 20 HDO, with real-time, peak, timing and average Measurement mode, can be connected to the computer for data management and analysis.
Using 320 × 240 color screen display, measurement accuracy of +/- 0.5%, support full angle measurement, can store 10000 data, Built-in Printer is convenient for on-site output, to meet the needs of a variety of hardness of materials testing.
Manual measurement of paint film Hardness, load 500g, test angle 45 °, can be inspected in any direction, three points contact with the measured surface.
