Measurement range 0-1000N penetration resistance, detection depth of 30 cm can be extended to 1.5 Meters, without the ring knife method can quickly obtain dry density data, complete the detection within 10 minutes.
Support 0 °, 10 °, 30 ° multi-angle test, equipped with 250mL liquid discharge funnel and 500mL measuringflask, can meet the needs of sanitary napkins and diapers at the same time, such as slippery penetration, re-penetration and other penetration performance measurement.
Support HDMI, WIFI and SD card three output, 1920 * 1080 resolution, can directly control camera paraMeters through USB mouse, embedded image capture and video recording, suitable for a variety of detection scenes.
Temperature range -50 to 300 ° C, Response Time of only 4 seconds, equipped with replaceable ultra-fast Response stainless steel penetration Probe, with CAL Check ™ Adjustment and battery error prevention system to ensure accurate and reliable measurement.
The penetration method is used for testing, a set of tests only takes 15-20 minutes, the measurement depth is 0-30cm, the accuracy is less than or equal to 0.25%, and there is no radioactive pollution.
Measurement range of 3.0-600 mm with 2MHz Frequency and 22mm diaMeter design, high penetration capability, suitable for thickness detection of a variety of good conductor materials.
The equipment performs 180 ° reciprocating folding test at a fixed speed of 87 times/minute, supports a variety of sample sizes (longest 88mm, widest 63mm), the thickness is suitable for materials ≤ 0.5mm, and is equipped with numerical control display to monitor the number of folds in real time.
With paint penetration measurement ability, accurate measurement of wall thickness without removing coatings, thickness range 2.5~ 125mm, accuracy +/- 0.03mm, support multi-echo and single-echo mode switching, suitable for detection needs of different surface conditions.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
It can measure the ability of the paint film to deform with the substrate without damage. It is equipped with a shaft Rod with a diaMeter of 50mm and 100mm.
The drying process of paint film and putty film can be accurately measured by using circular track needle design, equipped with four different radius needle (R0.25/0.5/1.0/1 mm), and the track period is 24h/r.
Impact height of 120 cm, hammer mass 1000g, no secondary rebound phenomenon after impact, punch diaMeter 16mm, can accurately determine the impact strength of the paint film.
Adopt all directions swing vibration mode to ensure that the paint is fully mixed, Vibration Frequency 550 times/min, equipped with 0-15 minute timing function, suitable for 80-240mm barrel height range.
The total weight of steel ball load is 135 +/- 5g, and the test displacement is 30 +/- 1 °, which can automatically detect water permeability and stop counting, and support the simultaneous testing of 1 to 4 test pieces.
The adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel ≥ 80mm. The integrity of the paint film was evaluated by seven grades, and the operation was simple and conformed to the GB/T1720 standard.
