Adopting three-roll extrusion friction grinding principle, Rotation speed 28-152rpm adjustable, fineness of grinding up to 15μm, Hardness HS70 ° above the surface of cold hard alloy steel roller, support water chilling down system, suitable for high viscosity material processing.
With 8L Processing capacity and 0.1μm discharge particle size, four-station design and 580rpm Rotation speed, support dry grinding, wet grinding and vacuum grinding, equipped with 600CFM cooling system and a variety of ball milling Tank material selection.
With double Tank grinding and 1-30Hz vibration Frequency adjustment, support low temperature grinding protection heat sensitive material, discharge particle size up to 5~ 10μm, can process more than 10 samples at a time and grinding time only 1-3 minutes.
Three rollers are used to squeeze each other and friction at different speeds to achieve grinding. The roller material is cold hard alloy cast iron, with surface Hardness HS70 ° or more, and the fineness of grinding can reach 15μm, which is suitable for high viscosity material processing.
The use of diamond sanding needles can flatten the surface of the grinding wheel, improve the utilization rate of abrasive wheels, and is equipped with a water supply system to support wet grinding and dry grinding. The size of abrasive wheels is about 250 × 30 × 32mm, and the Rotation speed is 1400rpm.
360 ° tumbling structure combined with planetary disk swirl/spin, maximum Processing capacity 16L, support dry and wet grinding vacuum grinding, can reach 0.1 μm discharge particle size, with a variety of ball mill Tank material and grinding mode selection.
The surface of three rollers is extruded and rubbed at different speeds to achieve grinding. The diaMeter of the roller is 65mm, and the fineness of grinding can reach 15μm. It is suitable for fine grinding and dispersion of high viscosity materials.
Double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support dry grinding, wet grinding and low temperature grinding, suitable for heat sensitive materials and minimal liquid nitrogen consumption.
The double Tank design is used to achieve high-throughput grinding, the vibration speed is adjustable from 60 to 1800rpm, and the discharge particle size is 5 to 10 μm. It supports dry grinding, wet grinding and low temperature grinding, and effectively protects the molecular structure of heat-sensitive materials.
Using double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support low temperature grinding protection of heat sensitive materials, a processing of more than 10 samples, grinding time only 1-3 minutes.
With 10L Processing capacity and 0.1μm discharge accuracy, four-station design and 580rpm Rotation speed, support wet and dry grinding and vacuum grinding, configuration 600CFM cooling system and a variety of materials ball mill Tank optional, good grinding conformity.
Using large-screen touch screen operation, intelligent control of grinding time and speed, grinding results are highly repeatability. The dual-Tank design supports high-throughput processing, and the discharge particle size can reach 5~ 10 μm. It is suitable for heat-sensitive materials and consumes very little liquid nitrogen.
Double Tank grinding design, vibration speed 60-1800rpm, discharge particle size up to 5~ 10μm, support low temperature grinding protection of heat sensitive materials, processing multiple samples at one time and high Repeatability.
Double disc independent control, stepless speed range of 50~ 1400rpm, can switch swirl/spin direction. DC brushless motor, low noise and strong torque, equipped with chilling down water pipe and grinding disc flushing function to prevent grinding material settling.
Rotation speed up to 900rpm, discharge particle size minimum 0.1um, with forward and reverse alternating operation and intermittent grinding function, support vacuum grinding and inert gas protection, more than ten kinds of material grinding Tank to ensure no pollution.
