Equipped with fixed K-type stainless steel penetration Probe, Response Time 20 seconds, IP65 waterproof standard, with CAL Check ™ calibrate inspection and battery error prevention system to ensure accurate and reliable measurement.
Response Time of only 4 seconds, temperature range of -50.0 to 300 ℃, equipped with replaceable ultra-fast Response K stainless steel penetration Probe, with CAL Check ™ calibrate inspection and automatic shutdown function.
The ring 6mm Probe design ensures good contact with the workpiece surface, the Teflon jacket is easy to clean and flexible and durable, the maximum temperature resistance is 300 ° C, and the lightweight shape avoids affecting the measurement accuracy.
Magnetic surface temperature measurement Probe through strong magnetic adsorption on the workpiece, small volume and light mass, Sensor and magnet insulation to ensure measurement accuracy, the highest temperature 480 ℃, especially suitable for circular workpiece surface.
Using fixed K type stainless steel penetration type temperature sensor, Response Time 20 seconds, temperature range coverage -50.0 to 300 ℃, in line with IP65 waterproof standards, to ensure stable work in harsh environments.
Dual Probe design can measure two samples at the same time, equipped with BEPS low power error prevention system to avoid wrong readings, Measurement accuracy of +/- 0.5 ℃, support K/J/T type multiple temperature sensors, waterproof design to adapt to complex environments.
The 90 ° right angle Probe design is suitable for low headroom area measurement, the fully waterproof structure supports underwater operation, the Measurement accuracy is +/- (0.05 mils + 1%), and the stainless steel sealing Probe ensures durability.
Using 2.0MHz Frequency Probe, Measurement range 2.0~ 400.0mm, dedicated to the thickness detection of coarse crystal materials such as cast iron, the lower limit of pipe measurement Φ 30 * 4mm.
With dual measurement interfaces to detect two samples simultaneously, support a wide range of Probe types covering -200 ° C to 1371 ° C, equipped with Adjustment and backlit display to ensure measurement accuracy and ease of operation.
With split Probe design, equipped with F and N Probe, Measurement range 0~ 1500 microns, resolution 0.1 microns, automatic identification of substrate type, support for more than 60 readings per minute, Protection Rating IP65.
Impact energy 11mN, Impact device mass 80g, suitable for measurement of slender narrow groove, can meet the needs of different shapes and sizes of workpiece Hardness detection.
Measurement range from -50.0 to 300 ° C with Response Time of only 20 seconds. Equipped with a replaceable T-type stainless steel penetrating Probe, it meets IP65 waterproof standards and has built-in calibrate inspection and battery error prevention for measurement Stability and durability.
Measurement accuracy of +/- 1% F.S. with 3.5-inch high-resolution IPS display, supports timing measurement and automatic scanning mode, and the standard temperature probe can directly display real-time temperature data.
Using 5MHZ Frequency and 10mm diaMeter Probe design, Measurement range 1.2-230 mm, the minimum pipe diaMeter can be measured Φ 20mm × 3mm, suitable for thickness detection in room temperature environment.
Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
