The sampling area is 100mm ² and the error is controlled within +/- 0.35cm ², which can handle 0.1~ 1.2mm Film thickness materials. The circular sampling design is used to ensure the standard of the sample, and the operation is simple and the results are reliable.
Special No. 10 steel high temperature quenching knife edge, smooth cutting without burrs; one-piece casting structure is sturdy and durable; sampling area 100cm ², error +/- 0.35cm ², suitable for 0.1~ 1.2mm Film thickness material.
The special No. 10 steel knife edge is used to ensure durability, the punching sample is smooth without burrs, the integrated casting structure is sturdy and not deformed, the sampling area is 100cm2, and the sampling Film thickness range is 0.01-1 mm.
Travel 0-1.25 mm, measurement error +/- 1HAM, suitable for thin rubber samples with a thickness of 1.5mm or more. Sensitivity is high, and it needs to be used with a constant load measuring rack to ensure Precision.
Sample pRoduction takes only 3-5 minutes without Resin solidification, cutting range 0.05-50 mm ², total video magnification 20-300X, Modular design to achieve pipeline operation, improve inspection accuracy and efficiency.
The sampling area is 100cm ², the sampling error is +/- 0.35cm ², the sampling thickness range is 0.1-3 mm, and the special treatment die blade is durable and free of replacement.
Travel 0-1.25 mm, measurement error +/- 1HAM, pressure at the end of the needle 324-764mN, suitable for thin rubber samples with a thickness of 1.5mm or more, and can be used with a fixed load measuring rack.
Simultaneous sampling ECT (100 * 25) mm and PAT (80 * 25) mm two sizes, sampling error +/- 0.5mm, thickness range ≤ 10mm, easy to operate.
Impact energy 2.7mJ, Impact device mass 75g, small damage to the measured surface, does not damage the hardened layer, suitable for measurement of small and thin parts, the minimum thickness of the specimen is 1mm, and the minimum depth of the hardened layer is 0.2mm.
12.7Mm ultra-thin body and 250g lightweight design for easy portability; CAL-CHECK system can prompt ElectRode contamination and buffer information; Support 1000 sets of Data storage and USB interface transmission; Automatically identify ElectRode type and enter Measurement mode, suitable for a variety of environments.
Suitable for thin samples with a thickness of less than 6mm, featuring multiple testing modes such as real-time, peak, automatic timing, and average value. It can be connected to a computer for data management and curve analysis.
Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
Using clutter flying technology implementation of 0.15mm ultra-thin parts measurement, the highest resolution of 0.001mm, support through coating measurement and Bluetooth communication, with voice broadcast and LED backlight function.
Frequency 10MHz, Measurement range 0.65~ 20mm, suitable for thin-walled and small curved surface workpieces, the lower limit of pipe measurement Φ 10 * 1.0mm.
Equipped with 254nm and 365nm dual-wavelength ultraviolet light sources, it supports thin-layer analysis and paper-layer analysis, can identify fluorescent substances, and is equipped with a 200 * 50mm filter.
