Using magnetic Induction and eddy Current dual principle, it can simultaneously measure paints and zinc layer thickness. Measurement range is 0-1500 μm, accuracy is +/- 1%, suitable for composite coating system inspection.
Measurement range 0~ 300μm, resolution up to 0.01μm, support multi-layer nickel potential difference analysis, test size optional Φ 2.4mm to Φ 0.8mm.
Using magnetic Induction and eddy Current principle simultaneous measurement composite coatings, Measurement range 0~ 1500μm, error +/- 1%, can display a single coating and zinc layer thickness, suitable for the accurate detection of ferrous and non-ferrous substrates.
Measurement range 0.03-50 um, resolution 0.01um, supports multi-layer platings and alloy platings measurement, with custom hotkeys and LCD display, easy to operate without adjusting Sensitivity.
Measurement range 0.03~ 50μm, resolution 0.01μm, support single-layer, multi-layer and alloy platings testing, built-in thermal printer to automatically output statistical reports, suitable for wire and columnar workpieces.
Measurement range 0.1~ 35μm, resolution 0.01μm, can measure more than 20 platings combinations such as Cr, Ni, Cu, etc., support single-layer and composite multi-layer measurement, equipped with 4 quick plating selection buttons to avoid misoperation.
Impact energy 3N, Impact device mass 75g, suitable for measurement of small or thin specimens and surface hardening layer, the minimum thickness can be measured 1mm and the minimum hardening layer depth 0.2mm.
Using high-speed ADC data collection, resolution up to 1μm, can simultaneously measure the thickness of multi-layer coatings or coatings plus substrates, with gain automatic switching and estimated thickness setting function, Measurement range 13~ 1000μm (epoxy resin coating).
Frequency 5.0MHz, support paint layer detection and emission to echo mode, Measurement range 2~ 160mm, suitable for a variety of workpiece thickness measurement.
Measurement range 0-12mm, Accuracy of 1-3%, Support automatic identification of matrix material and continuous Measurement mode, suitable for pipeline anticorrosive layer defect location.
Using Spectrophotometric method, spectra-trophotometry to detect nickel concentration, detection limit of 0.1mg/L, equipped with imported cold light source life of 100,000 hours, support a variety of Measurement mode and wireless data transmission function.
Using electromagnetic induction principle to achieve nondestructive detection, measurement range of 0-9500μm, accuracy +/- 3%. With continuous single double measurement mode, automatic identification of substrate material, support 2000 sets of data storage and four statistical functions.
The device can precisely control the film thickness of the ink layer of the color strip, and the ink injection amount is 0.0012g, which is used for ink contrast and color concentration detection.
Using Spectrophotometric method, specs-trophotometry to detect nickel content, Measurement range 0.00-7 g/L, accuracy +/- 0.10g/L, equipped with LED@575nm Illuminant, easy to operate without complex pretreatment, suitable for rapid batch detection needs.
Using magnetic Induction principle to achieve 0-6000μm large-range measurement, the error is only +/- 3%. With continuous single double measurement mode, support four-point statistical function, large-capacity storage of 2000 sets of data, automatic identification of matrix material.
