Using 2.0MHz Frequency Probe, Measurement range 2.0~ 400.0mm, dedicated to the thickness detection of coarse crystal materials such as cast iron, the lower limit of pipe measurement Φ 30 * 4mm.
Measurement range 0.75~ 225mm, error as low as +/- 0.05mm, support automatic zero-point calibrating and two-point calibrating, with coupling status prompt and over-limit alarm function.
Measurement range 0.75-300 mm, support Speed of sound back measurement and Automatic calibration, with EL backlight and coupling status prompt, suitable for harsh industrial environments.
Impact accuracy is ensured by double-tube guide structure, the maximum impact energy can reach 320J, the impact height error is controlled within +/- 2mm, and the automatic hammer lifting function is equipped to prevent secondary impact.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
Suitable for material measurement with temperature less than 350 ℃, with 5.0MHz Frequency and lower limit of pipe measurement Φ 25 * 3mm, to meet the needs of accurate thickness detection in high temperature environment.
Measurement range 0.75-400 mm, accuracy +/- 0.5% H + 0.05mm, support Speed of sound measurement and coupling status prompt, equipped with USB/RS-232C Interface.
Measurement range 1.2~ 200mm, resolution 0.1mm, coupled state prompt and RS-232C data output function, adapt to different Frequency Probe.
The stainless steel pendulum pipe is used to achieve +/- 180 degree swing, equipped with 25 water spray holes and 1-4 rpm adjustable turntable, supporting 50-100kpa water pressure adjustment, and the test water can be recycled without additional waterproof treatment.
Using 5MHz Sensor to achieve 0.5% H + 0.1mm accuracy, with sound speed measurement and coupling prompt function, support USB, RS-232 and Bluetooth data output mode.
Frequency 10MHz, Measurement range 0.65~ 20mm, suitable for thin-walled and small curved surface workpieces, the lower limit of pipe measurement Φ 10 * 1.0mm.
Measurement accuracy of 0.5% H +/- 0.2mm, resolution of 0.01mm, with coupling status prompt and automatic memory function, support USB and Bluetooth data output, easy to operate and portable.
Using 7.5MHz High Frequency Probe, Measurement range 0.7~ 50mm, suitable for thin-walled and small arc surface workpieces, the lower limit of pipe measurement is Φ 25 * 1.2mm, strong adaptability.
Frequency 7MHz, Probe diaMeter 6mm, can be measured thin-walled and small arc surface, minimum pipe diaMeter Φ 15mm, Measurement range 0.75-80 mm, suitable for different environmental conditions.
Using 5.0MHz Frequency, Measurement range 0.8-300 mm, suitable for flat or large radian surface, pipe measurement lower limit Φ 25 * 1.2mm, support a variety of working conditions detection.
